| Plaster of Paris | One Coat | One Coat Elite | Stucco | Gypsum Board |
_____________________________________________________________________________________________________
Stucco Gypsum Plaster
Stucco plaster is a gypsum based plaster suitable for application on most internal backgrounds including bricks, block and concrete. It consists of gypsum hemihydrates formulated with special additives to enhance workin & setting characteristics.
It contains light weight exfoliated aggregates to improve plasters workability, coverage, appliction & post usage behavious.
It dries to provide an off-white, smooth matt finish. |
|
________________________________________________________________________________________________________
Features of Uttam Gypsum - Stucco Plaster :-
- Direct application, Single coat application
- Free of Cracks
- high coverage of 90m?Mt*
- Very Smooth finish
- No maintainance required
- Compatible with all types of paints.
- Enhance light reflectance. Imparts true color tone & gloss for paints.
- Available in HDPE bags packaging.*
|
|
____________________________________________________________________________________________________
Performance Drivers of Utam Gypsum - Stucco Plaster
Parameters
- Dry Bulk Density
- Wet Bulk Density
- Initial setting time
- Final setting time
- App. coverage*
|
Units
Kg/m
gm/cm
mins
mins
m/t |
Stucco
650 - 710
1.40 - 1.50
20 - 22
22 - 25
87 - 92
|
Application methodology : Surface Preparation
- The background to be plastered should be thoroughly brushed with a broom to be free of all particles & background dust and clean traces of mould oil.
- In case of hacking, provide 50 hacks (should be minimum 10-15mm).
- It is recommended to pre wet th surface so as to achieve more spread and higher coverage.
- Mix stucco plaster to water, use a mixing rod for thorough mixing and avoid lumps and unmixed residues.
- Water to plaster ratio (1 part water : 2 parts of plaster) should be maintained to have a good cohensive workable mix.
- Mix stucco plaster as much as required depending upon the immediate scoop of work, partially unused material to be kept well secured in dry place.
- Once the mix has began to set, additional water should be added, as performance properties of one stucco plaster will get altered, thus affecting workability, cohensive, adhesion and strength.
- Avoid using a wet brush on the finished surface as that would leave permanant brush marks and thus spoil the surface.
- A single coat should not exceed 13mm in thickness. If at all thickness more than 3mm is required, plaster should be applied in multiple coats.
- After complete drying (usually takes 72 hrs depending on the thickness & weather conditions), the plain smooth levelled surfce is ready for painting.
|